Table of Contents
Advertisement
„ Display
❏ The display does not light up
• When the Dimmer function is working, the display may go dim. Press the DIMMER button, and change the brightness level of the display.
• The display is turned off when the Pure Audio (Asian models) listening mode is selected.
„ Others
❏ Strange noise can be heard from the unit
• If you have connected another device to the same outlet as this unit, strange noise may occur under the influence of the device. If the symptom is
remedied by removing the power plug of the other device from the outlet, use different outlets for this unit and the device.
❏ The message "Noise Error" appears during AccuEQ Room Calibration
• This can be caused by a malfunction in your speaker unit. Check the speaker output, etc.
❏ The measurement results of AccuEQ Room Calibration show different distances to the speakers from
the actual ones
• Depending on the speakers you are using, some errors may occur in the measurement results. If this is the case, make the settings in "2.
Speaker" - "Distance" in the Setup menu.
Contents
Connections
≫
141
Front Panel≫ Rear Panel≫ Remote≫
Playback
Setup
≫
≫
(
p16)
(
p110)
≫
Advertisement
Chapters
Table of Contents
Troubleshooting
