Onkyo TX-NR595 Instruction Manual page 110

Setting Item Default Value Setting Details
Surround 100 Hz Select the crossover frequency from "40 Hz" to
"200 Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
• If the item cannot be selected even though
Surround Back 100 Hz Select the crossover frequency from "40 Hz" to
"200 Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when
• If the item cannot be selected even though
LPF of LFE 120 Hz Set the low-pass filter for LFE (low-frequency
effect) signals in order to pass only the lower
frequency signals than the set value, and thus
cancel unwanted noises. The low-pass filter is
effective only on sources with LFE channel.
The value from "80 Hz" to "120 Hz" can be set.
"Off": When this function is not used
Double Bass On This can be selected only when "Configuration"
- "Subwoofer" is set to "Yes" and "Front" is set to
"Full Band".
Bass output is boosted by feeding bass sounds
from the front right and left, and center speakers to
the subwoofer.
"On": Bass output is boosted.
"Off": Bass output is not boosted.
• This function is not automatically set even if
Contents
set to "Full Band".
connection is correct, check if the setting in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
"Surround" is set to "Full Band".
connection is correct, check if the setting in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
AccuEQ Room Calibration is performed.
Connections
≫
„ 3. Distance
Set the distance from each speaker to the listening position.
Setting Item Default Value
Front Left 12.0 ft/3.60 m
Center 12.0 ft/3.60 m
Front Right 12.0 ft/3.60 m
Height Left 9.0 ft/2.70 m
Height Right 9.0 ft/2.70 m
Surround Right 7.0 ft/2.10 m
Surr Back Right 7.0 ft/2.10 m
Surr Back Left 7.0 ft/2.10 m
Surround Left 7.0 ft/2.10 m
Subwoofer 12.0 ft/3.60 m
• Default values vary depending on the regions.
110
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
• The setting cannot be changed if "Configuration"
- "Zone Speaker" is set to "Zone 2" and Zone 2
is on.
Specify the distance between each speaker and
the listening position.
• The setting cannot be changed if "Configuration"
- "Zone Speaker" is set to "Zone 2" and Zone 2
is on.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
• The setting cannot be changed if "Configuration"
- "Zone Speaker" is set to "Zone 2" and Zone 2
is on.
Specify the distance between each speaker and
the listening position.
• The setting cannot be changed if "Configuration"
- "Zone Speaker" is set to "Zone 2" and Zone 2
is on.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
≫