Onkyo TX-NR595 Instruction Manual page 109

Setting Item Default Value Setting Details
Bi-Amp No Set whether the front speakers are bi-amp
connected.
"No": When front speakers are not bi-amp
connected
"Yes": When front speakers are bi-amp connected
• This setting is fixed to "No" if "Zone Speaker" is
• This setting cannot be selected when surround
Speaker 6 ohms or above Set the impedance (Ω) of the connected speakers.
Impedance "4ohms": When any of the connected speakers
have 4 Ω or more to less than 6 Ω impedance
"6 ohms or above": When the connected speakers
all have 6 Ω or more impedance
• For impedance, check the indications on the
Contents
set to "Zone 2".
back speakers or height speakers are installed.
back of the speakers or their instruction manual.
Connections
≫
„ 2. Crossover
Change the settings of crossover frequencies.
Setting Item Default Value
Front 100 Hz
Center 100 Hz
Height 100 Hz
109
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Select the crossover frequency from "40 Hz" to
"200 Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• If "Configuration" - "Subwoofer" is set to "No",
"Front" is fixed to "Full Band", and the low
pitched range of the other channels is output
from the front speakers. Refer to the instruction
manual of your speakers to make the setting.
Select the crossover frequency from "40 Hz" to
"200 Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
set to "Full Band".
• If the item cannot be selected even though
connection is correct, check if the setting in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Select the crossover frequency from "40 Hz" to
"200 Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
set to "Full Band".
• If the item cannot be selected even though
connection is correct, check if the setting in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
≫