Onkyo TX-NR595 Instruction Manual page 112

„ 6. Equalizer Settings
You can adjust the output volume of the range for each connected speaker.
Adjust the volume of different sound ranges for each speaker. You can set three
different equalizers in Preset 1 to 3. The number of frequencies that can be
selected for each speaker is up to five bands for the Subwoofer and nine bands
for the other speakers.
Setting Item Default Value
Front 0.0 dB
Center 0.0 dB
Height 0.0 dB
Surround 0.0 dB
Surround Back 0.0 dB
Setting Details
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
• The setting cannot be changed if "Configuration"
- "Zone Speaker" is set to "Zone 2" and Zone 2
is on.
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
• The setting cannot be changed if "Configuration"
- "Zone Speaker" is set to "Zone 2" and Zone 2
is on.
Contents Connections
≫
Setting Item Default Value
Subwoofer 0.0 dB
• Depending on the input source or listening mode setting, the desired effect may not be
achieved.
„ 7. Speaker Virtualizer
The Speaker Virtualizer function can be switched between On and Off.
Setting Item Default Value
Speaker On
Virtualizer
112
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
After selecting the speaker frequency between
"25 Hz" and "160 Hz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
• This cannot be selected if "Configuration" -
"Subwoofer" is set to "No".
Setting Details
When this is set to "On", a virtual speaker can be
set.
"On": When this function is used
"Off": When this function is not used
• When this is set to "Off", some of the listening
p85
modes cannot be selected. ( )
≫