Onkyo TX-NR595 Instruction Manual page 114

„ 5. Volume
Change the Volume settings.
Setting Item Default Value
Mute Level -∞ dB
Maximum Volume Off
Power On Volume Last
Headphone Level 0 dB
Setting Details
Set the volume lowered from the listening volume
when muting is on. Select a value from "-∞ dB",
"-40 dB" and "-20 dB".
Set the maximum value to prevent the volume from
becoming too loud. Select a value from "Off", and
"50" to "99".
Set the volume level of when the power is turned
on. Select a value from "Last" (Volume level before
entering standby mode), "Min", "1" to "99" and
"Max".
• You cannot set a higher value than that of
"Maximum Volume".
Adjust the output level of headphones. Select a
value between "-12 dB" and "+12 dB".
Contents Connections
≫
4. Source
„ 1. IntelliVolume
Adjust the volume level when there are differences in volume level among multiple
devices connected to this unit. Select the input selector to make the setting.
Setting Item Default Value
IntelliVolume 0 dB
„ 2. Name Edit
Set an easy name for each input. The set name appears on the main unit's
display. Select the input selector to make the setting.
Setting Item Default Value
Name Edit Input name
114
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Select a value between "-12 dB" and "+12 dB".
Set a negative value if the volume of the target
device is larger than the others and a positive
value if smaller. To check the audio, play back the
connected device.
• This function does not work in Zone 2.
Setting Details
1. Select a character or symbol with the cursors,
and press ENTER.
Repeat this operation to input up to 10
characters.
"A/a": Switches between upper and lower cases.
(Pressing MODE on the remote controller also
toggles between upper and lower cases)
"←" "→": Moves the cursor in the arrow direction.
" ": Removes a character on the left of the
cursor.
" ": Enters a space.
• Pressing CLEAR on the remote controller will
remove all the input characters.
2. After inputting, select "OK" with the cursors, and
press ENTER.
The input name will be saved.
To restore the name to the default value, press
CLEAR on the remote controller on the input
screen. Then while nothing is entered, select "OK",
and press ENTER.
≫