Dell PowerEdge R760xs Installation And Service Manual page 51

Table 49. HTTP Device n Settings details (continued)
Option
Gateway
DNS info via DHCP
Primary DNS
Secondary DNS
URI (will obtain from
DHCP server if not
specified)
TLS Authentication
Configuration
Table 50. ISCSI Device1 Settings screen details
Option
Connection 1
Connection 2
Connection 1 Settings
Connection 2 Settings
Connection Order
Table 51. Connection 1 Settings details
Option
Interface
Protocol
VLAN
VLAN ID
VLAN Priority
Retry Count
Timeout
DHCP
Initiator IP Address
Initiator Subnet Mask
Initiator Gateway
Target info via DHCP
Target Name
Target IP Address
Target Port
Description
Specifies gateway for the HTTP device.
Enables or disables DNS Information from DHCP. This option is set to Enabled by default.
Specifies the primary DNS server IP address for the HTTP Device.
Specifies the secondary DNS server IP address for the HTTP Device.
Obtain URI from the DHCP server if not specified
Specifies the option for TLS authentication configuration.
Description
Enables or disables the iSCSI connection. This option is set to Disabled by default.
Enables or disables the iSCSI connection. This option is set to Disabled by default.
Enables you to control the configuration for the iSCSI connection.
Enables you to control the configuration for the iSCSI connection.
Enables you to control the order for which the iSCSI connections will be
attempted.
Description
Specifies NIC interface used for the HTTP device.
Specifies Protocol used for HTTP device. This option is set to IPv4 or IPv6. This option is set
to IPv4 by default.
Enables VLAN for HTTP device. This option is set to Enable or Disable. This option is set to
Disable by default.
Shows the VLAN ID for the HTTP device
Shows the VLAN Priority for the HTTP device.
Specifies the retry count for Connection 1 Settings. This option is set to 3 by default.
Specifies the time out for Connection 1 Settings. This option is set to 10000 by default.
Enables and disables the DHCP for Connection 1 Settings. This option is set to Disabled by
default.
Specifies the Initiator IP Address for Connection 1 Settings.
Specifies the Initiator Subnet Mask for Connection 1 Settings.
Specifies the Initiator Gateway for Connection 1 Settings.
Enables and disables the Target DHCP for this iSCSI connection. This option is set to Disabled
by default.
Shows the Target name for this iSCSI connection in IQN format.
Shows the Target IP Address for this iSCSI connection.
Shows the Target Port for this iSCSI connection. The standard port number for iSCSI
connections is 3260.
Pre-operating system management applications 51