Pci-8366 Low-Profile Bracket Installation Instructions - National Instruments PCI-8361 User Manual

PCI-8366 Low-Profile Bracket
Installation Instructions
This appendix describes how to install a low-profile bracket on the PCI-8366. For specifications
for the PCI-8366, refer to Appendix B,
Installing the PCI-8366
1. Disconnect the fiber optic cable from the cabled PCI Express connector.
2. Move the release lever downwards until it is pointing towards you.
3. Gently pull the release lever toward you to release the catch mechanism of the SFP module.
The SFP module should easily slide out of the receptacle as shown in Figure D-1.
3
2
1
1 Release Lever
2 Cabled PCI Express Connector
4. Remove the two 4-40 × 1/4 inch Phillips head screws that attach the standard height bracket
to the card as shown in Figure D-2. Set the screws aside to re-use when installing the
low-profile bracket.
Specifications for Legacy
Figure D-1. SFP Module Removal
Products.
4
3 SFP Module
4 SFP Receptacle
© National Instruments Corporation | D-1
D