Verify The Installation - National Instruments PCI-GPIB Installation Manual

Complete the following steps to change the default parameters of your
NI-488.2 software. The driver should not be in use while you run .
ibconf
1. Log on as superuser ( ).
root
2. Type the following command to start :
ibconf
ibconf
After you have installed and configured the software, you should verify the
installation. Refer to the Verify the Installation section.
Removing NI-488.2 (Optional)
If you ever decide to stop using your PCI-GPIB, PXI-GPIB, or PMC-GPIB, you
can remove the board and the NI-488.2 software. To remove NI-488.2 from the
kernel configuration, you must have superuser privilege and the driver must not
be in use. Enter the following command to unload the software:
pkgrm NIpcigpib

Verify the Installation

This section describes how to verify the software installation.
Verifying the System Boot Messages
If a message in the following format displays on the console or in the
command tool window during software installation, the driver has established
communication with the hardware device and recognized it.
Installing Your GPIB Hardware and NI-488.2 for Solaris 10 ni.com