Table of Contents
Advertisement
Installation and Configuration
This chapter explains how to install and configure your 671X device.
Software Installation
Install your software before you install the 671X device. Refer to the
appropriate release notes indicated below for specific instructions on the
software installation sequence.
1.
2.
You can now install your hardware.
Hardware Installation
You can install the PCI/PXI-6711/6713 device in any available PXI/PCI
expansion slot in your computer. You can connect the DAQPad-6713 to
any available 1394 port on your PC or another 1394 device. You can install
the DAQCard-6715 in any available 5 V PC Card slot in your computer.
However, to achieve best noise performance, leave as much room as
possible between the 671X device and other devices and hardware. The
following are general installation instructions, but consult your computer
user manual or technical reference manual for specific instructions and
warnings.
♦
PXI-6711/6713
You can install the PXI-6711/6713 in any available PXI slot in your PXI or
CompactPCI chassis.
© National Instruments Corporation
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Install your application software—If you are using LabVIEW,
LabWindows/CVI, or other National Instruments application software
packages, refer to the appropriate release notes.
Install the NI-DAQ driver software—Refer to your NI-DAQ release
notes and follow the instructions given there for your operating system
and application software package.
2-1
2
6711/6713/6715 User Manual
Advertisement
Table of Contents
