Removing The Water Separator And Water Drain Valve - Carrier EverFRESH Operation, Service And Parts Manual

Water Separator
Wat e r Dr ai n
Valve (WDV)
5.3.1

Removing the Water Separator and Water Drain Valve

This procedure is for removing the Water Separator and Water Drain Valve (WDV) for cleaning and inspection.
1. Open the panel needed to gain access to the water separator
accessed from the front of the unit through the upper left access panel, or from inside the container through
the EverFRESH access panel door.
2. Cut the tie on the Vent Position Sensor (VPS) wiring to relieve tension. Unplug the VPS if installed and
remove the access panel.
3. Remove the bolt holding the manifold to the frame, using a 1/4" socket and 11/32" nut driver or wrench.
Figure 5.1 Filter Assembly
5–15
Particulate Filters
(Figure 5.1). This component can be
T-374