Air Compressor Minor Rebuild - Carrier EverFRESH Operation, Service And Parts Manual

2. Install the remaining seven bracket bolts and then torque to 30 to 35 ft-lbs. (41 to 47 Nm).
3. Install the discharge line. Tighten with a 5/8" wrench and then torque to 23 in-lbs. (2.6 Nm).
4. Connect the air compressor power connection and wire tie the harness to the drain line and yellow power
cable. Maintain a drip loop on the power line prior to entering the compressor motor.
5. Replace the air compressor splash shield. Torque the four bolts to 60 in-lbs. (6.8 Nm).
5.2.5

Air Compressor Minor Rebuild

Before proceeding with installation, set the ON/OFF switch and circuit breaker to OFF position.
Disconnect power plug from the unit. Follow all local Lockout / Tagout Procedures.
Required Supplies
• Minor Rebuild Kit (part number 18-10185-20)
• Loctite 222 or equivalent
• Torque Wrench capable of 200 in-lbs (22.6 Nm)
• Standard hand tools: 3/16" hex key, 3/4" wrench, phillips screwdriver, gasket removal tool
WARNING
!
5–5 T-374