Carrier EverFRESH Operation, Service And Parts Manual page 40

9. Remove the old gasket material from the cylinder head and cylinder using a gasket removal tool. Ensure all
parts are clean and free of debris.
Procedure for Reassembly
1. Install silver rings on the piston first.
2. Install the black ring over the silver ring on the piston. Open slightly to get over the piston and slide into
place. Offset the ring gap by 180 degrees.
3. Hold the piston rider rings in place and slide the cylinder over the piston. Hold in place with two hex key bolts
provided in the kit. Rotate the compressor until the piston is at the top of the cylinder. Position the cylinder so
the piston does not go beyond the top of the cylinder. Torque to 150 to 160 in-lbs. (17 to 18 Nm).
T-374 5–8