Carrier EverFRESH Operation, Service And Parts Manual page 44

Procedure for Disassembly
1. Remove eight phillips screws from the protective shield. Remove the shield.
2. Loosen the two crossover bar compression nuts for one of the heads using a 3/4" wrench.
3. Remove the head with loosened crossbar nuts using a 3/16" hex key. Remove the four head bolts and pull
off the head assembly including valve plates. Discard all components except for the crossbar.
4. Remove crossbars from the air compressor using a 3/4" wrench.
T-374 5–12