Table of Contents
Advertisement
Industrial Electronic Devices
TRANSLATE TABLE:
Within the section "Translate Table" it is possible to
define the variables that can be read or written by the
TCP bus on the RTU bus when the device is in NAT
mode.
By pressing the
"Translate
main window for SW67507 (Fig. 2), the window "Set
Translate Table" appears (Fig. 4).
The data of the columns have the following meanings:
In the field
"Data
Type" the type of data for the
Modbus translation is defined;
In the field
"Slave ID
virtual Modbus TCP node is defined;
In the field
"Address
TCP" the Modbus Address of the virtual TCP node is defined;
In the field
"Slave
ID" the ID of the Modbus slave to poll is defined;
In the field "Address" the Modbus address of the data on the RTU device is defined;
In the field "NPoint" the number of consecutive registers to read/write is defined;
In the field "Mnemonic" a brief description is defined.
ADFweb.com S.r.l.
Table" button from the
Figure 4: "Set Translate Table" window
TCP" the address of the
User Manual Modbus TCP Slave / Modbus Master
Document code: MN67507_ENG
Revision 2.400
Page 34 of 45
Advertisement
Table of Contents
