To Set The Jetclean Parameters For The Clean Only Mode - Agilent Technologies 5977C Series Operating Manual

4 Operating in EI Mode

To Set the JetClean Parameters for the Clean Only Mode

To Set the JetClean Parameters for the Clean
Only Mode
Procedure:
1 In Instrument Control view, click the MS Parameters icon.
2 In the Single Quadrupole MS Method Editor, select the JetClean tab. (See
3 From the Operation dropdown menu, select Clean Only.
Figure 33
4 Enter the parameters supplied by your method developer.
5 Save the method.
5977C GC/MSD Operating Manual
Figure 33.)
JetClean set to Clean Only mode
103