Table of Contents
Advertisement
1
Introduction
Intended Use
Intended Use
Agilent products must be used only in the manner described in the Agilent
product user guides. Any other use may result in damage to the product or
personal injury. Agilent is not responsible for any damages caused, in whole or in
part, by improper use of the products, unauthorized alterations, adjustments, or
modifications to the products, failure to comply with procedures in Agilent
product user guides, or use of the products in violation of applicable laws, rules,
or regulations.
Cleaning/Recycling the Product
To clean the unit, disconnect the power and wipe down with a damp, lint-free
cloth. For recycling, contact your local Agilent sales office.
Agilent recommends you retain the original packaging that your product arrived
in so it can be used to ensure the safe movement or transport of your product in
the future. If you must discard any of the packaging, we recommend following
local waste disposal regulations to ensure the largest amount of material is
recycled and diverted from a landfill or incineration. For additional guidance,
please refer to your local waste disposal authority.
Accidental Liquid Spillage
Do not spill liquids on the MSD. If liquid is accidentally spilled on the MSD, first,
cut the power. Once the MSD is disconnected from all power sources, dry all
affected parts. If the liquid spillage affects the electronics, wait at least 24 hours,
depending upon the ambient humidity. While waiting for the parts to dry, please
call your local Agilent service representative.
Moving or Storing the MSD
The best way to keep your MSD functioning properly is to keep it pumped down
and hot, with carrier gas flow. If you plan to move or store your MSD, additional
precautions are required:
•
•
5977C GC/MSD Operating Manual
The MSD must remain upright at all times; this requires special caution when
moving.
The MSD should not be left vented to atmosphere for long periods.
31
Hide quick links:
Advertisement
Table of Contents
