Preparing the installation site ................................................................................................................................................

7.1.1

Installation site requirements of the indoor unit ..................................................................................................

7.1.2

Special requirements for R32 units .......................................................................................................................

7.1.3

Installation patterns ...............................................................................................................................................

7.2

Opening and closing the units................................................................................................................................................

7.2.1

About opening the units ........................................................................................................................................

7.2.2

To open the indoor unit .........................................................................................................................................

7.2.3

To close the indoor unit .........................................................................................................................................

7.3

Mounting the indoor unit.......................................................................................................................................................

7.3.1

About mounting the indoor unit............................................................................................................................

7.3.2

Precautions when mounting the indoor unit ........................................................................................................

7.3.3

To install the indoor unit........................................................................................................................................

Choose an installation location with sufficient space to transport the unit in and

out of the site.

Do NOT install the unit in places often used as work place. In case of construction

works (e.g. grinding works) where a lot of dust is created, the unit MUST be

covered.

WARNING

The appliance shall be stored in a room without continuously operating ignition

sources (example: open flames, an operating gas appliance or an operating electric

heater).

WARNING

DO NOT reuse refrigerant piping that has been used with any other refrigerant.

Replace the refrigerant pipes or clean thoroughly.