I/O Bracket - HP EliteOne 800 G4 Maintenance & Service Manual

I/O bracket

The I/O bracket is located under the plastic rear I/O cover. It is secured with five Torx screws, one of which is
under the power connector.
To remove the I/O bracket:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
3. Remove the rear port cover (see
4. Remove the stand (see
5. Remove the access panel (see
6. Remove the rear I/O cover (see
7. Remove the power connector from its mounting location on the I/O bracket (see step 3 in
on page
8. Remove the five Torx screws that secure the I/O bracket to the computer.
9. Lift the I/O bracket from the computer.
To replace the I/O bracket, reverse the removal procedures.
Access panel on page
Removing the rear port cover on page
Stands on page
Access panel on page
Rear I/O cover on page
40).
Preparing to disassemble the computer on page
20).
19).
20).
42).
18).
18).
Power supply
I/O bracket 43