Table of Contents
Advertisement
There are two memory slots on the system board. To remove or install memory modules:
1.
Prepare the computer for disassembly (see
2.
Remove the rear port cover (see
3.
Remove the stand (see
4.
Remove the access panel (see
5.
To remove a memory module, press outward on the two latches on each side of the memory module (1),
then pull the memory module out of the slot (2).
6.
Slide the new memory module into the slot at approximately a 30° angle (1), then press the memory
module down (2) so that the latches lock it in place.
NOTE:
A memory module can be installed in only one way. Match the notch on the module with the tab
on the memory slot.
7.
Reassemble the computer.
The computer automatically recognizes the additional memory when you turn on the computer.
Preparing to disassemble the computer on page
Removing the rear port cover on page
Stands on page
19).
Access panel on page
18).
20).
18).
Memory
27
Advertisement
Table of Contents
