Basic Installation Procedures
This section provides sample installation information as a guide
for your installation. For your convenience, the overall procedure
is divided into these main steps:
NOTE: For marine applications, see additional installation
instructions on page 41.
975-0784-01-01
Installation Tools and Materials
You will need the following to install the Freedom XC:
Wire stripper
n
Mounting (#2) screws or bolts
n
#2 Phillips torque screwdriver
n
15
Torque wrench for DC terminals (½" or 13mm socket
n
16
wrench)
22
AC cable (that is, two-conductor-plus-ground cable), sized
n
appropriately for load and application
23
½" (or ¾") trade-size strain relief clamps (for the AC cable
n
25
clamp holes)
Wire nuts or crimp connectors for AC wire and appropriate
n
31
tools
DC cable, sized appropriately for load and application
n
36
Lugs for DC cables to fit
n
38
appropriate tools (like a crimping tool)
AC and DC disconnects and over-current protective devices
n
Basic Installation Procedures
5
" DC stud terminals as well as
/
16
15