Omron CS Series Operation Manual page 86

Converting from Previous Models
60
• If the Mode Change was Completed Normally
Node address
×16 1 ×16 0
0 F
• If an Error Occurred in the Mode Change
Node address
1 0
×16 ×16
0 F
Note If an error occurs in the mode change, remove the Ethernet Unit,
create the I/O tables, and correct the settings using the procedures
described in this section.
7. Turn OFF the power to the PLC and return the Ethernet Unit's rotary
switches for the node address to its original setting.
8. Turn ON the power to the PLC.
Node address
×16 1 ×16 0
- -
Indicators
RUN ERC
Flashing Lit
Indicators
RUN ERC
Flashing Lit
Indicators
RUN ERC
Lit Not lit
Section 2-11
ERH
Lit
ERH
Not lit
ERH
Not lit