Communications Test; Ping Command - Omron CS Series Operation Manual

Communications Test

Automatic Clock Adjustment
Web Functions

2-10 Communications Test

2-10-1 PING Command

52
CX-Programmer tab
Receive Mail Posting Mail Address Protection Setting
Receive Attached File Setting
Receive Command Setting
For details, refer to SECTION 3 Mail Receive Function in the Operation Man-
ual Construction of Applications.
CX-Programmer tab
DNS IP Address
Port No.
Retry timer
Auto Adjust Time SNTP Server Setup
Auto Adjust Time
Server specification type
IP Address
Host name
Port No.
Retry timer
Adjust Time
For details, refer to SECTION 5 Automatic Clock Adjustment Function in the
Operation Manual Construction of Applications.
CX-Programmer
tab
HTTP Use Web function
Password
Port No.
For details, refer to Appendix G Ethernet Unit Web Function.
If the basic settings (in particular the IP address and subnet mask) have been
made correctly for the Ethernet Unit, then it should be possible to communi-
cate with nodes on the Ethernet.
This section describes how to use the PING command to perform communi-
cations testing between Ethernet Units.
The PING command sends an echo request packet to a remote node and
receives an echo response packet to confirm that the remote node is commu-
nicating correctly. The PING command uses the ICMP echo request and
responses. The echo response packet is automatically returned by the ICMP.
The PING command is normally used to check the connections of remote
nodes when configuring a network. The Ethernet Unit supports both the ICMP
echo request and reply functions.
Settings
Settings
Setting item
Section 2-10