Sony SRG-A40 Command List page 68

Parameter
V6SynFloodExpire
V6SynFloodLimit
V6SynFloodProtection
iplimit.cgi
Setting (Set): command/iplimit.cgi?<Parameter>=<Value>
Inquiry (Inq): command/inquiry.cgi?inq=iplimit
<n> of the parameter tail is the number between 1 to 10. Corresponds to the IP Limit 1 to 10 which can
be registered to the camera.
The admin can access from even IP address whose access is denied by IP Limit.
Parameter (<n>: 1 to 10)
IpLimit<n>
IpLimitFunc
IpLimitNum
IpLimitPolicy
Set
Value
Inq
Set 60
Inq 10 to 86400
Set 5
Inq 1 to 1000
Set on, off
Inq
Set
Value
Inq
Set [Value1]
Inq IPv4 or IPv6 address
[Value2]
8 to 128
[Value3]
allow, deny
Set on, off
Inq
Inq 10
Set allow, deny
Inq
68
Description
Setting of the predetermined time to
discard the results judged as an attack with
IPv6 SYN Flood Attack Protection function.
(unit: second)
Setting of the possible access times per
minute after limiting with IPv6 SYN Flood
Attack Protection function.
On/Off setting of IPv6 SYN Flood Attack
Protection function.
Description
Setting that to be registered on numbers
specified in <n>.
IpLimit<n>=Value1,Value2,Value3
[Value1]
Setting of IP address
[Value2]
Setting of subnet mask
The numbers from 8 to 32 can be used for
IPv4, and the ones from 8 to 128 for IPv6.
[Value3] Policy
Setting of access policy
allow : Client with IP address specified in
Value1 and Value2 will be allowed
to access to the cameras
deny : Client with IP address specified in
Value1 and Value2 will be denied
access to the cameras
On/Off setting of IP Limit function.
IP Limit function returns the maximum
numbers of IP addresses that can be
registered.
Setting of IP Limit function policy.
allow : All the other accesses whose
settings are not specified by
IpLimit<n> parameter will be
allowed.
deny : All the other accesses whose
settings are not specified by
IpLimit<n> parameter will be
denied.