Sony SRG-A40 Command List page 65

filtering.cgi
Setting (Set): command/filtering.cgi?<Parameter>=<Value>
Inquiry (Inq): command/inquiry.cgi?inq=filtering
<n> of the parameter tail is the number between 1 to3. Corresponds to the IPv4 filter 1 to 3 or IPv6 filter
1 to 3 which can be registered to the camera.
Note
If you set V4FilterDefaultRule or V6FilterDefaultRule to reject with setting IP address to grant access
unregistered, even the Admin cannot access with CGI command. In this case, revert to the default status
using Reset switch on the Camera.
Parameter
DosDefenseRuleNum
FragmentDeny
V4DosDefenseBurst<n>
V4DosDefenseEnable<n>
V4DosDefenseExpire<n>
V4DosDefenseLimit<n>
V4DosDefensePort<n>
V4FilterDefaultRule
V4FilterFunc
Set
Value
Inq
Inq 3
Set on, off
Inq
Set 3
Inq 2 to 600
Set on, off
Inq
Set 60
Inq 1 to 86400
Set 5
Inq 1 to 100
Set 80
Inq 0 to 65535
Set allow, reject
Inq
Set on, off
Inq
65
Description
Returns possible numbers for DoS
Protection setting.
Setting whether the Fragment packet is
denial or not.
on : Denies Fragment packet
off : Does not deny Fragment packet
Setting of consecutive access numbers to
be judged as being attacked by IPv4 DoS
attack protection function.
On/Off Setting of IPv4 DoS attack
protection function.
Setting of the predetermined time to
discard the results judged as a DoS attack
by IPv4 DoS attack protection function.
(Unit: second)
Setting of the possible request times per
minute after limiting the upper limit of
access with the IPv4 DoS attack protection
function.
Setting of the port number to defend
against requests with the IPv4 DoS attack
protection function.
Setting of the basic policy for IPv4 IP Filter.
allow : All the other accesses whose
settings are not specified by
V4FilterRule parameter will be
allowed.
reject : All the other accesses whose
settings are not specified by
V4FilterRule parameter will be
denied.
On/Off setting of IPv4 IP Filter function.