Water Tank & Drain Hose - INVENTOR CF-ION-10L User Manual

9. WATER TANK & DRAIN HOSE
There are two ways to remove collected water. Before proceeding ensure that you have
switched off and unplugged the unit.
1. Usage of the water tank
When unit is OFF and the tank of the dehumidifier is full, the full indicator will be lit.
Additionally, when the unit is on and the tank is full, the compressor stops operation
followed by the fan a few minutes later. The full indicator will flash.
• Slowly remove the bucket. Grip the handle with caution and carefully pull outwards so
the water does not overflow. Do not place the tank on the floor because the bottom of
the tank is uneven. Doing so the tank will fall and the water will be spilled on the floor.
• Empty the water from the tank and place it again in to the device. The water tank, must
be securely and properly placed, for the dehumidifier to operate.
• When the water tank is re-installed the unit will automatically restart.
2. Continuous draining
Water automatically can be
emptied into a floor drain by
attaching the unit with a water
hose.
• Remove the plastic cover
located opposite the unit.
Insert the water hose into the
drain outlet and make sure
all connections are firmly
tightened in order to avoid
any possible leaks.
• The dehumidifier should be
placed on a flat surface in an
upright position.
• Lead the water hose towards
a suitable drainage facility
and be certain that the water
flows naturally. For correct
drainage, make sure the hose
stays below the level of the
drain hose outlet.
EN
• When you remove the tank, do not touch any parts
inside the unit, as you may damage the device.
• Be sure to gently place the tank into the dehumidifier.
• Do not drink or use the collected water from the device.
• Wipe any excess water on or in the unit when removing
the tank.
Always check if
the cut section
of the water
tank is clean
Insert the water hose from
the drain outlet
23