After Operation; After Operation Safety; Finishing The Job - Toro Maxi Sneaker 370 Operator's Manual

Plow (continued)
5. Reduce the attachment speed to a point with the least machine vibration and the highest
ground drive speed possible.
6. Check the installed product for any damage during plowing.

Finishing the Job

1. When the installation is complete, move the ground drive control to N
2. With the vibrator running, raise the plow to ground level while reducing the vibrator
speed.
Note:
3. Move the plow vibrator control to O
4. Engage the parking brake.
5. Shut off the machine and remove the product from the plow.
6. Swing the plow to the center position and engage the swing lock.
7. Start the engine.
8. Disengage the parking brake.
9. Drive a short distance away from the work site.
10. Shut off the machine.

After Operation

After Operation Safety

• Shut off the engine, remove the key, wait for all movement to stop, and allow the machine
to cool before adjusting, cleaning, storing, or servicing it.
• Do not touch parts that may be hot from operation. Allow them to cool or wear gloves
before attempting to maintain, adjust, or service the machine.
• Clean debris from the attachments, drives, mufflers, and engine to help prevent fires.
Clean up oil or fuel spills.
Finishing the Job
1. After the product is installed, return the spoils to the trench with shovels or small earth-
moving equipment.
2. Clean the machine.
3. Ensure that tools and accessories are loaded and properly secured on the trailer or
truck.
Operation: During Operation
Do not operate the vibrator when the plow is out of the ground.
.
FF
Page 5–12
.
EUTRAL
3455-524 A