Toro Maxi Sneaker 370 Operator's Manual page 70

Changing the Hydraulic Fluid (continued)
3. Remove the lower right side cover plate and
loosen the hose clamp holding the suction
hose to the hydraulic tank
4. Remove the left side cover plate and loosen
the 3 hose clamps under the hydraulic tank
.
5. Disconnect the electrical lead to the fluid
temperature sensor at the bottom of the
reservoir
6. Remove the bolts securing the tank straps.
7. Remove the hydraulic tank.
8. Flush the reservoir with cleaning solvent.
9. Remove the elbow adapters and clean the
filter screens with compressed air.
Note:
adapters.
10. Apply thread sealant to the threads of the
suction screen and install the screen, elbow,
hose, and clamp.
11. Connect the electrical lead to the fluid
temperature sensor.
12. Connect the hose to the tank and secure with the clamps.
13. Install the hydraulic tank assembly.
14. Fill the tank.
15. Install the dipstick cap.
16. Start the engine and allow it to run for a few minutes.
17. Shut off the engine.
18. Check the hydraulic fluid level.
19. Add fluid as needed to keep the level at the line on the dipstick.
Maintenance: Hydraulic System Maintenance
.
Make a note of the orientation of the
.
G416161
G416162
Page 7–19 3455-524 A