Toro Maxi Sneaker 370 Operator's Manual page 45

Plow (continued)
Attaching the Product
1. Insert the material into the pulling grip.
2. Tape the grip with duct tape.
3. Remove the cable guide.
4. Feed the cable through the tube from the top to
the bottom.
5. Replace the cable guide and tighten the
fasteners.
6. Secure the cable.
Preparing the Machine for Plowing
1. Start the engine.
2. Set the throttle to S
3. Disengage the parking brake.
4. Move the ground drive control to S
Plowing
1. Move the ground drive control forward to the plowing speed and lower the plow blade
into the ground.
Note:
2. Set the throttle to F
3. Move the plow vibrator control to O
Note:
4. Lower the plow blade into the ground to its full depth.
3455-524A
.
LOW
Do not drive the machine in reverse with the plow blade in the ground.
.
AST
Do not operate the vibrator unless the plow is in the ground.
G425616
G425615
.
LOW
.
N
Page 5–11 Operation: During Operation