Breaking In The Machine; Becoming Familiar With The Machine; After Operation; After Operation Safety - Toro Sand Pro 3040 Operator's Manual

Breaking in the Machine

New engines take time to develop full power. Drive
systems have more friction when they are new,
placing additional load on the engine.
Allow the first 8 hours of operating time for the
break-in period.
Since the first hours of operation are critical to future
dependability of the machine, monitor the functions
and performance closely so that you can notice and
correct minor difficulties, which could lead to major
problems. Inspect the machine frequently during
the break-in period, for signs of oil leakage, loose
fasteners, or any other malfunction.
Becoming Familiar with the
Machine
Refer to the attachment Operator's Manual for specific
operating instructions for the attachment.
Practice driving the machine, because its operating
characteristics are different than some utility vehicles.
2 points to consider when operating the vehicle are
transmission speed and engine speed.
To maintain constant engine speed, press the traction
pedal slowly. This allows the engine to keep up
with the ground speed of the vehicle. By contrast,
pushing down quickly on the traction pedal reduces
the engine speed; as a result, there will not be enough
torque-power to move the vehicle. Therefore, to
transfer maximum power to the wheels, move the
throttle to F and slightly press the traction pedal.
AST
By comparison, maximum ground speed with no load
results when the throttle is in the F
traction pedal is slowly but fully pressed. Always keep
the engine speed high enough to deliver maximum
torque-power to the wheels.
CAUTION
Operating the machine demands attention to
prevent tipping or loss of control.
• Use care when entering and leaving sand
traps.
• Use extreme caution around ditches,
creeks, or other hazards.
• Use caution when operating the machine
on a steep slope.
• Reduce your speed when making sharp
turns or when turning on hillsides.
• Avoid sudden stops and starts.
• Do not go from reverse to full forward
without first coming to a complete stop.
position and the
AST
18
Note:
If the attachment adapter becomes stuck to the
traction unit adapter, insert a pry bar or a screwdriver
into the pry slot to disengage the parts
Figure 16
1. Pry slot

After Operation

After Operation Safety

•
Park the machine on a level surface; engage the
parking brake; shut off the engine; remove the key;
and wait for all movement to stop before leaving
the machine.
•
Clean grass and debris from the muffler and
engine compartment to help prevent fires. Clean
up oil or fuel spills.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Shut off the fuel before storing or transporting the
machine.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Replace all worn, damaged, or missing decals.
(Figure 16).
g003783