Table of Contents
Advertisement
Note:
If the attachment adapter becomes stuck to the
traction unit adapter, insert a pry bar or a screwdriver
into the pry slot to disengage the parts
Figure 16
1. Pry slot
After Operation
(Figure
16).
After Operation Safety
•
Park the machine on a level surface; engage the
parking brake; shut off the engine; remove the key;
and wait for all movement to stop before leaving
the machine.
•
Clean grass and debris from the muffler and
engine compartment to help prevent fires. Clean
up oil or fuel spills.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Shut off the fuel before storing or transporting the
machine.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
g003783
•
Replace all worn, damaged, or missing decals.
Towing the Machine
In case of emergency, you can tow the machine for a
short distance. However, we do not recommend this
as a standard procedure.
Important:
km/h (1 mph), because drive system damage may
occur. If you must move the machine more than
50 m (55 yd), transport it on a truck or a trailer.
The tires may lock up if you tow the machine too
fast. If this occurs, stop towing the machine and
wait for the traction circuit pressure to stabilize
before resuming towing at a slower speed.
Hauling the Machine
•
Use full-width ramps for loading the machine onto
a trailer or truck.
•
Tie the machine down securely.
18
Do not tow the machine faster than 1.6
Advertisement
Table of Contents
