After Operation; After Operation Safety; Exiting The Machine - Toro Outcross 9060 Series Operator's Manual

Canceling a Parked or Recovery Regeneration
Use the P R
ARKED EGEN
regeneration process.
1. Access the DPF Regeneration menu, scroll down to the P
option.
2. Press the next screen to cancel a Parked Regen or cancel a Recovery Regen.

After Operation

After Operation Safety

•
Before leaving the operating position, do the
following:
– Park the machine on a level surface.
– Move the shift lever to the N
– Engage the parking brake.
– Lower all attachments.
– Shut off the engine and remove the key.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Do not store the machine where there is an open
flame, spark, or pilot light.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Maintain and clean the seat belts as necessary.
•
Replace all worn, damaged, or missing decals.

Exiting the Machine

WARNING
Improperly exiting the machine can cause
injury.
Always use the handle and step to exit
the machine. To avoid injury while exiting,
maintain a 3-point contact: 1 hand on the
handle and 2 feet on the step.
Exit the machine as shown in
C or R
ANCEL ECOVERY
position.
EUTRAL
Figure 64.
R C setting to cancel a running parked or recovery
EGEN ANCEL
ARKED
1. Handle
51
R option or the R
EGEN
Figure 64
2. Step
R
ECOVERY EGEN
g256168