Dalsa Falcon 4-CLHS Series User Manual page 30

Manufacturer Info
Firmware Version
Serial Number
Device User ID
Temperature
Input Voltage
Device Built-In Self Test
Status
Device Built-In Self Test
Status All
Refresh BIST
Device Reset
Power-on User Set
Factory Setting
User Set 1
User Set 2
User Set Selector
Factory Setting
28  Operational Reference
DeviceManufacturerInfo
DeviceFirmwareVersion
DeviceSerialNumber
DeviceUserID
DeviceTemperature
deviceInputVoltage
deviceBISTStatus
FPGA_ECHO_BACK
FLASH_TIMEOUT
FLASH_ERROR
NO_FPGA_CODE
NO_COMMON_SETTINGS
NO_FACTORY_SETTINGS
OVER_TEMPERATURE
SENSOR_PATTERN
CLHS_TXRDY_RETRY
INVALID_UPGRADE
NO_USER_SETTINGS
deviceBISTStatusAll
deviceBIST
DeviceReset
UserSetDefaultSelector
UserSetSelector
This feature provides extended manufacturer
information about the device. Falcon4
cameras show which firmware design is
currently loaded.
Displays the currently loaded firmware version
number. Firmware files have a unique number
and have the .cbf file extension.
Displays the device's factory set serial
number.
This feature stores a user-programmable
identifier.
Internal temperature in degrees Celsius
Voltage at power connector (V)
List the BIST status. Display the most critical
error if there are multiple errors.
Passed No errors.
I2C Errors on I2C devices.
SENSOR_CAL Sensor calibration failed.
SENSOR_SPI Sensor SPI failed self test.
FPGA failed echo back.
SPI flash timeout.
SPI flash ID invalid (communication fail).
FPGA: no code in SPI flash.
No common settings.
No factory settings.
Over temperature.
Sensor Test pattern failed.
CLHS Tx Retry.
Firmware upgrade failure.
No user settings.
NO_SCRIPT No start script.
FACT_CODE Run from factory code.
NO_FATFS No FAT filesystem.
WRONG_DAC Wrong DAC values.
Result of Basic Internal Self-Test
Refresh Basic Internal Self-Test
Write to this feature to reset the device to its
power up state.
Selects the feature User Set to load at camera
reset.
Default Select the default camera feature settings
saved by the Factory.
UserSet1 Select the user defined configuration UserSet
1 as the Power-up Configuration.
UserSet2 Select the user defined configuration UserSet
2 as the Power-up Configuration.
Selects the camera configuration set to load
feature settings from or save current feature
settings to. The Factory set contains default
camera feature settings.
Default Select the default camera feature settings
saved by the factory.
1.00
Beginner
1.00
Beginner
1.00
Beginner
1.00
Beginner
1.00
Beginner
1.00
DFNC
Beginner
1.00
Beginner
1.00
DFNC
Beginner
1.00
Beginner
1.00
Beginner
1.00
Beginner
1.00
Beginner
Falcon™ 4-CLHS Series