Removing The Node Cover - Supero FatTwin F628R2-FC0 User Manual

6-6

Removing the Node Cover

Each node has a removable cover which will permit access to the nodes components.
Removing the Node Cover
1. Power down the system and remove the power cord from the rear of the
power supply as described in Section 6-3. Remove the node from the chassis
as described in Section 6-4 and place the node on a fl at, stable surface.
2. Remove the screws securing the cover to the node, as illustrated below.
3. Lift the cover up and off the node.
Figure 6-7: Removing the Node Cover
6-9
Chapter 6: Advanced Chassis Setup