Removing Nodes From The Chassis; Removing The Cover From The Node - Supero FatTwin F617R3-FT User Manual

FatTwin F617R3-FT USER'S MANUAL
6-5

Removing Nodes from the Chassis

Each of the eight individual nodes may be removed from the chassis. Note that
when a node is removed from the chassis, the hard drives located in the node will
shut-down.
Removing a Node
1. Power down the system and remove the power cords from the rear of the
node as described in Section 6-3.
2. Grasp the node by the handles on either side of the front of the node.
3. Carefully pull the node forward and out of the chassis.
6-6

Removing the Cover from the Node

Removing the Node Cover
1. Remove the power cord from the node as described in Section 5-2 and
remove the node from the chassis as described in Section 5-4.
2. Remove the two screws on either side of the rear of the node.
3. Lift the cover up and off the node.
Figure 6-3: Removing the Node Cover
6-4