Connecting Cables; Connecting Data Cables; I/O Ports - Supero FatTwin F628R2-FC0 User Manual

FatTwin F628R2-FC0 USER'S MANUAL
5-2

Connecting Cables

Now that the processors are installed, the next step is to connect the cables to
the serverboard.

Connecting Data Cables

The cables used to transfer data from the peripheral devices have been carefully
routed in preconfi gured systems to prevent them from blocking the fl ow of cooling
air that moves through the system from front to back. If you need to disconnect
any of these cables, you should take care to reroute them as they were originally
after reconnecting them (make sure the red wires connect to the pin 1 locations). If
you are confi guring the system, keep the airfl ow in mind when routing the cables.
See Chapter 1 for details on cables for the F628R2-FC0 server.
5-3

I/O Ports

The rear I/O ports are in conformance with the PC 99 specifi cation. See Figure 5-1
below for the colors and locations of the various I/O ports.
1
Back Panel I/O Port Locations and Defi nitions
1
2
3
4
5
6
7
Figure 5-1. Rear I/O Ports
2 3 4
Back Panel USB 3.0 Port 1
Back Panel USB 3.0 Port 2
Gigabit LAN Port 1
Gigabit LAN Port 2
IPMI LAN Port
VGA Port
Power Switch LED
5 6
5-2
7