Control Panel; Removing The Chassis Cover - Supero SUPERSERVER 1018R-WC0R User Manual

S S
UPER ERVER 1018R-WC0R User's Manual
Power Supplies
6-2

Control Panel

The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the motherboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the motherboard to the Control Panel PCB (printed circuit
board). Make sure the red wire plugs into pin 1 on both connectors. Pull all excess
cabling out of the airflow path. The LEDs inform you of system status.
See Chapter 3 for details on the LEDs and the control panel buttons. Details on
JF1 can be found in Chapter 5.
6-3

Removing the Chassis Cover

Removing the Chassis Cover
1. Power down the system and remove the power cords from the rear of the
power supplies.
2. Simultaneously press down on the two release buttons on the chassis cover.
3. Slide the cover toward the rear of the chassis.
4. Lift the cover off the chassis.
Figure 6-1. Front and Rear Chassis Views
Hot-Swap Drive Bays (10)
Rear I/O Ports (see Section 5-3)
PCIe Expansion Slots (w/ Riser Card)
6-2
Control Panel
USB Ports