KTM 450 EXC-F 2018 Setup Instructions page 17

–
Position the main silencer. Mount screws
washers, but do not tighten yet.
–
Attach spring
Spring hook (50305017000)
–
Tighten screws
Guideline
Remaining screws,
chassis
E00487-10
–
Attach the side cover in area
–
Mount and tighten screw
Guideline
Screw, sub-
frame
–
Mount and tighten screw
Guideline
Remaining screws,
E00494-10
chassis
–
Install the battery. (
–
Install the fuel tank. (
–
Position turn signal on both sides, mount nuts with wash-
ers and tighten.
–
Position license plate lamp on the license plate holder,
and mount and tighten screws
–
Mount reflector
–
Pass cable through the license plate holder.
E00496-10
–
Position license plate holder on the license plate holder.
–
Join the plug-in connector of the license plate lamp.
–
Connect the plug-in connector of the left turn signal which
is marked red.
–
Connect the plug-in connector of the right turn signal
which is marked green.
–
Mount and tighten screws
E00497-10
9
8
.
9
.
M6 10 Nm (7.4 lbf ft)
A and engage it in area
7
.
M8 35 Nm (25.8 lbf ft)
6
.
M6 10 Nm (7.4 lbf ft)
p. 27)
p. 31)
bq
.
br
on license plate holder.
bo
.
2 SETUP
with the
B .
Loctite ® 2701™
15