KTM 450 EXC-F 2018 Setup Instructions page 15

–
Remove screws
–
Carefully pull the tail light cable out of the frame, paying
attention to the plug as you do so.
–
Take off license plate holder with tail light toward the rear.
S01416-10
–
Remove screws
–
Drill a hole at the marking
E00491-10
–
Route the turn signal cable harness toward the rear and
pass through the frame paying attention to the plugs as
you do so.
–
Route turn signal cable harness on the license plate holder
and pass turn signal cable harness through the drill hole.
–
Position tail light on license plate holder, and mount and
tighten screws
E00492-10
bo
.
bp
and hang the tail light to the side.
C
to the size of the marking.
bp
.
2 SETUP
13