KTM 450 EXC-F 2018 Setup Instructions page 13

–
Position turn signal cable harness.
–
Insert the indicator lamp with the black and violet cable
colors into socket
S01393-10
–
Position turn signal on the headlight mask on both sides,
mount nuts with washers and tighten.
–
Connect the plug-in connector of the right turn signal using
the black and brown cables of the turn signal cable har-
ness.
–
Connect the plug-in connector of the left turn signal using
the violet and brown cable colors of the turn signal cable
harness.
E00484-10
Info
Pay attention to where the brake line is routed when
doing so.
–
Connect plug-in connector of the headlight.
–
Connect plug-in connector of the turn signal switch.
–
Secure turn signal relay
the connector.
–
Install the headlight mask with the headlight. (
–
Route the turn signal cable harness from the front to the
back as far as the battery compartment.
–
Position and secure turn signal cable harness using cable
ties to the main wiring harness under the rubber bands of
fuel tank support.
S01418-01
–
Remove screw
–
Remove screw
–
Pull off the side cover in area
it toward the rear.
E00494-10
4
.
5
with a cable tie and plug in
6
.
7
.
A B
and area
2 SETUP
p. 20)
and remove
11