Technical Specifications - Fieldmann FDUB 50701 Instruction Manual

7. TECHNICAL SPECIFICATIONS

MULTI FUNCTION TOOL :
Speed
Protection class:
Declared noise level
Vibration:
Instructions Manual - language version only.
Amendments to text and technical parameters are reserved.
Changes in the text, design and technical specifi cations may change without prior notice and
we reserve the right to make these changes.keep it from turning as the drill bit rotates.
Troubleshooting
1. The trigger is pressed but the device is not working: For the cordless device to work, you need a
sufficiently charged battery. The battery will go flat if you do not use the cordless device for an
extended period of time. Try charging the battery. Check that the battery is correctly seated in
the charger. The charger will heat up while charging, this is normal.
2. The battery is leaking: At extreme temperatures or when under extreme load, a small amount of
leakage may occur. If you happen to touch the fluid, immediately wash it off your skin or clothing
with soap and water.
3. The battery is not charging and the light on the charger is not lit: If the battery is not charging,
check that it is correctly seated in the charger and check that the indicator light is lit. If it is not lit,
check that the power plug of the charger is correctly plugged into the socket. If it is, check the
socket's fuse/circuit breaker.
4. The body of the device heats up after extended use: Under normal load the body, trigger and
battery will heat up because the energy consumed when drilling generates heat. This is normal.
Simply allow the device to cool down for several minutes.
5. The battery heats up during use: Energy drawn from the battery generates heat. It does not
damage the battery, heat from drawing energy is normal. If you wish to cool the battery down,
allow the device to cool down for a few minutes before continuing with work.
6. The battery heats up while charging: This is normal and is the result of chemical reactions taking
place inside the battery during the charging process.
7. The charging unit will heat up while charging: This is normal and is caused by the reduction of
voltage from 230V to 18V.
MULTI FUNCTION TOOL
Technical specifications
5 000– 18 000rpm
II
105dB(A)
ah.D1=3.415ms – ah.D1=8.397ms
-2
23 EN
, K=1.5ms
-2 -2
OPERATING INSTRUCTIONS