Machine Care; Warranty; Technical Specifications - Fieldmann FDP 200451-E Manual

EN 14
Machine care | Warranty | Technical specifications

8. MACHINE CARE

Overload
Never use excessive force when cutting. Too much pressure reduces the speed of the machine, and the required
power is greatly reduced. This may result in overload which can damage the motor of the machine. When the
machine becomes too hot, allow it to run for two minutes at no load and then interrupt working for a short time.
Clean the machine with a clean cloth and a brush. Ensure that the ventilation slots are not blocked.

9. WARRANTY

The Warranty Card shall be valid only when submitted together with the purchase receipt.
Keep the both documents in a safe place. To lodge a warranty complaint, turn to your dealer or a service centre.
The warranty shall apply to all product defects and faults that occurred during the warranty period and were
demonstrably attributable to material or manufacturing defects. In such cases the product shall be repaired
and/or adjusted. The warranty shall not apply to standard wear of the product, as well as to faults attributable to
overloading, using of inappropriate accessories or improper operation of the product.

10. TECHNICAL SPECIFICATIONS

Voltage
Power rating
No-load speed
Max.
Wood
Steel
Mitre angle
Instructions Manual - language version only.
220V 50 Hz
450W
0–3000/min
Cutting depth in
55 mm
6 mm
0–45°
FDP 200451-E