2N Analog Vario Installation Manual page 58

The code lock uses the same passwords as the ones that have been defined for the telephone
based switch control. Remember that the default passwords (00 for switch 1 and 11 for switch 2)
cannot be entered from the numerical keypad because they are notoriously known.
Control
Enter the correct password and
predefined time (5seconds by default). The corresponding switch is activated during this time. If
the password is invalid, 2N
Traditional Button Telephone
Any number can be "dialled" in this mode. To dial, press
keys are typically provided with pictograms
in the PBX. The dialling type (tone, pulse) is selected in the programming mode. With pulse
dialling, the character initiates (upon off-hook) transition to tone dialling – like on any other
telephone.

Note
• If this function is enabled, you can press
by pressing a separate button.
DTMF Transmission during Outgoing Call
This function enables the unit to transmit DTMF tones when the connection with one of the pre-
programmed numbers has been established. It is used in combination with automatic
information systems, voice mailboxes, etc., which ask the calling party to select a service using
tone dialling. This function, however, does not allow you to call destinations other than the pre-
programmed ones.
Buttons Substitution
This function is an analogy to memories in comfortable telephone sets. After two digits ranging
between 01 and 54 (0 may not be omitted) are pressed, the call to the pre-programmed number
is made. You can use 2N
the extender units and space on the installations wall. The ideal solution is to use a few standard
buttons for the most important speed dialling options e.g. Warden, Reception and then provide
a list of pre-programmed options via the optional info panel that can be purchased.
Admissible Keypad Function Combinations
. If the password is valid, a long tone is transmitted for a
®
Analog Vario sends a refusal signal.
®
Analog Vario as if it had up to 54 separate buttons, which saves buying
Installation manual 2N® Analog Vario
, and to hang up use
and . PSTN calls can be barred for a line
to hang up an outgoing call initiated
. These
58 / 77