Table of Contents
Advertisement
94
2. Instrument cluster
■
Engine speed
On hybrid vehicles, engine speed is precisely controlled in order to help
improve fuel efficiency and reduce exhaust emissions etc.
There are times when the engine speed that is displayed may differ even
when vehicle operation and driving conditions are the same.
■
Outside temperature display
In the following situations, the correct outside temperature may not be dis-
played, or the display may take longer than normal to change:
●
When stopped, or driving at low speeds (less than 25 km/h [16 mph])
●
When the outside temperature has changed suddenly (at the entrance/exit
of a garage, tunnel, etc.)
●
When "" or "E" is displayed, the system may be malfunctioning.
Take your vehicle to your Toyota dealer.
■
Fuel gauge and driving range display
The fuel gauge and driving range display are linked. If the fuel gauge and
driving range display do not update after refueling a small amount, they can
be updated by performing the following procedure:
1
Stop the vehicle on a level surface.
Wait until the fuel in the fuel tank stabilizes.
2
Press the ODO/TRIP switch to change the odometer and trip meter display
to the odometer.
3
Turn the power switch off.
4
While pressing and holding the ODO/TRIP switch, turn the power switch to
ON mode.
5
Continue holding the ODO/TRIP switch for approximately 5 seconds.
Release the switch when the odometer begins blinking.
Updating will be complete when the odometer blinks for approximately 5
seconds and then returns to the normal display.
NOTICE
■
To prevent damage to the engine and its components
The engine may be overheating if the engine coolant temperature gauge is
in the red zone (H). In this case, immediately stop the vehicle in a safe
place, and check the engine after it has cooled completely. (P. 469)
Advertisement
Table of Contents
