Table of Contents
Advertisement
464
7-2. Steps to take in an emergency
Connect the jumper cables according to the following procedure:
4
Connect a positive jumper cable clamp to the exclusive jump
1
starting terminal on your vehicle.
Connect the clamp on the other end of the positive cable to the
2
positive (+) battery terminal on the second vehicle.
Connect a negative cable clamp to the negative (-) battery termi-
3
nal on the second vehicle.
Connect the clamp at the other end of the negative cable to a
4
solid, stationary, unpainted metallic point away from the exclusive
jump starting terminal and any moving parts, as shown in the
illustration.
Start the engine of the second vehicle. Increase the engine speed
5
slightly and maintain that level for approximately 5 minutes to
recharge the 12-volt battery of your vehicle.
Open and close any of the doors of your vehicle with the power
6
switch off.
Maintain the engine speed of the second vehicle and start the
7
hybrid system of your vehicle by turning the power switch to ON
mode.
Make sure the "READY" indicator comes on. If the indicator does
8
not come on, contact your Toyota dealer.
Advertisement
Table of Contents
