Table of Contents
Advertisement
Brake Hold
The brake hold system keeps the brake applied when the shift
lever is in D, S or N with the system on and the brake pedal has
been depressed to stop the vehicle. The system releases the
brake when the accelerator pedal is depressed with the shift
lever in D or S to allow smooth start off.
Turns the brake hold system on
The brake hold standby indicator
(green) comes on. While the sys-
tem is holding the brakes, the
brake hold operated indicator (yel-
low) will illuminate.
*
1
: Brake hold standby indicator
*
2
: Brake hold operated indicator
■
Brake hold system operating conditions
The brake hold system cannot be turned on in the following conditions:
●
The driver's door is not closed.
●
The driver's seat belt is not buckled.
If either of the above is detected when the brake hold system is enabled, the
system will turn off and the brake hold standby indicator light will go off. In
addition, if any of the conditions are detected while the system is holding the
brakes, a warning buzzer will sound and a message will be shown on the
multi-information display. The parking brake will then be set automatically.
4-2. Driving procedures
*
1
223
4
*
2
Advertisement
Table of Contents
