Table of Contents
Advertisement
Figure 61. Front VGA assembly installation
After installing front VGA assembly, complete the following steps:
1. Reinstall the fan cage (see
2. Reinstall the top cover (see
3. Reconnect the power cords and any cables that you removed.
4. Power on the server and any peripheral devices.
LOM adapter replacement
Use the following procedures to remove and install the LOM adapter.
Remove the LOM adapter
Use this procedure to remove the LOM adapter.
Before removing the LOM adapter:
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
"Power off the server" on page
3. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top
cover, or remove the server from the rack.
4. Remove the top cover (see
To remove the LOM adapter, complete the following steps:
Step 1.
Loosen the captive thumbscrew.
Step 2.
Open the retention latch.
Step 3.
Remove the screw that fixes the LOM adapter.
"Install the fan cage assembly" on page
"Install the top cover" on page
55).
11).
"Remove the top cover" on page
67)
146).
"Safety" on page iii
and
145).
.
Chapter 3
Hardware replacement procedures
"Installation
75
Advertisement
Table of Contents
