Enable Uefi Secure Boot - Lenovo 7X18 Maintenance Manual

c. Navigate to the version of Lenovo XClarity Essentials OneCLI for your operating system and
download the package.
2. Run the following command to set the TPM version:
Note: You can change the TPM version from 1.2 to 2.0 and back again. However, you can toggle
between versions a maximum of 128 times.
To set the TPM version to version 2.0:
OneCli.exe config set TrustedComputingGroup.DeviceOperation "Update to TPM2.0 compliant"
-–bmc userid:password@ip_address
To set the TPM version to version 1.2:
OneCli.exe config set TrustedComputingGroup.DeviceOperation "Update to TPM1.2 compliant"
-–bmc userid:password@ip_address
where:
• <userid>:<password> are the credentials used to access the BMC (Lenovo XClarity Controller
interface) of your server. The default user ID is USERID, and the default password is PASSW0RD
(zero, not an uppercase o)
• <ip_address> is the IP address of the BMC.
For more information about the Lenovo XClarity Essentials OneCLI
http://sysmgt.lenovofiles.com/help/topic/toolsctr_cli_lenovo/onecli_r_set_command.html
3. Alternatively, you can use the following Advanced Settings Utility (ASU) commands:
To set the TPM version to version 2.0:
asu64 set TPMVersion.TPMVersion "Update to TPM2.0 compliant" --host <ip_address>
--user <userid> ––password <password> ––override
To set the TPM version to version 1.2:
asu64 set TPMVersion.TPMVersion "Update to TPM1.2 compliant" --host <ip_address>
--user <userid> ––password <password> ––override
where:
• <userid> and <password> are the credentials used to the BMC (Lenovo XClarity Controller interface)
of your server. The default user ID is USERID, and the default password is PASSW0RD (zero, not an
uppercase o)
• <ip_address> is the IP address of the BMC.

Enable UEFI Secure Boot

Optionally, you can enable UEFI Secure Boot.
There are two methods available to enable UEFI Secure Boot:
• From Lenovo XClarity Provisioning Manager
To enable UEFI Secure Boot from Lenovo XClarity Provisioning Manager:
1. Start the server and press the key specified in the on-screen instructions to display the Lenovo
XClarity Provisioning Manager interface. (For more information, see the "Startup" section in the LXPM
documentation compatible with your server at
lxpm_product_page.html
2. If the power-on Administrator password is required, enter the password.
https://sysmgt.lenovofiles.com/help/topic/lxpm_frontend/
.)
command, see:
set
.
Chapter 3 Hardware replacement procedures
139