Ceiling/Wall Mounting With Junction Box - HIKVISION TURBO HD H1T Series User Manual

Figure 2-2 Fix the Camera to the Ceiling
Note:
In the supplied screw package, both self-tapping

screws, and expansion blots are contained.
If the ceiling/wall is cement, expansion blots are

required to fix the camera. If the ceiling/wall is
wooden, self-tapping screws are required.
5. Connect the corresponding power cord, and video
cable.
6. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the surveillance angle.
1) Loosen the No.1 adjusting screw to adjust the
pan position [0° to 360°].
2) Tighten the No.1 adjusting screw.
3) Loosen the No.2 adjusting screw to adjust the
tilting position [0° to 90°].
4) Tighten the No. 2 adjusting screw.
5) Loosen the No.3 adjusting screw to adjust the
rotation position [0° to 360°].
6) Tighten the No.3 adjusting screw.
0° to 360°
0° to 90°
2.1.2 Ceiling/Wall Mounting with
Note:
You need to purchase a junction box separately if you
adopt the mounting with a junction box
Steps:
1. Paste the drill template on the ceiling/wall.
2. Drill screw holes and the cable hole in the
ceiling/wall according to the holes of the drill
template.
3. Take apart the junction box, and align the screw
holes of the bullet camera with those on the
Junction box' cover.
4. Fix the camera on the junction box's cover.
0° to 360°
Figure 2-3 3-axis Adjustment
Junction
Box
.