HIKVISION TURBO HD H1T Series User Manual page 14

LIVE DPC, WHITE DPC and BLACK DPC are adjustable in
this section.
LIVE DPC: Detects and corrects the dynamic or the
real-time defective pixels occur during the using. ON, and
OFF are selectable. The correction level from 0 to 255 is
configurable if the LIVE DPC is set as ON, set it as OFF to
disable the live defective pixel correction.
WHITE DPC: White DPC is the pixel on CCD or CMOS
sensor that appear completely white. Move the cursor to
the white DPC, and press Iris+ to enter the white DPC
configuration interface.
BLACK DPC: Black DPC is the pixel on CCD or CMOS
sensor that appear completely black. Move the cursor to
the white DPC, and press Iris+ to enter the black DPC
configuration interface.
LANGUAGE
Supports English, and Chinese.
3.8 ADJUST
In the ADJUST sub-menu, you can configure the settings,
including the sharpness, monitor, and the LSC (lens
shading compensation). Move the cursor to ADJUST
and click Iris + to enter the adjust configuration
interface.
Figure 3-6 ADJUST
SHARPNESS
Sharpness determines the amount of detail an imaging
system can reproduce. And you can adjust the
sharpness from 0 to 15. The higher the value, the
clearer and sharper the image appears.
MONITOR
GAMMA, BLUE GAIN, and RED GAIN are selectable.
GAMMA is the name of a nonlinear operation used to
code and decode luminance or tristimulus values in
video or still image system，with USER, 0.45, 0.50, 0.55,
0.60, 0.65, 0.70, 0.75, 0.80, 0.85, 0.90, 0.95, and 1.00
are selectable.
BLUE GAIN can be adjusted from 0 to 100.
RED GAIN Can be adjusted from 0 to 100.
LSC
Lens shading correction corrects the phenomenon that
the image gets darkened or blurred on the periphery.
Set it as ON, move the cursor to SCAN and click Iris+ to
correct the lens shading. Set it as OFF to disable the
LSC.
3.9 EXIT
RESET
Move the cursor to RESET and click Iris+ to reset all the
settings to the default.
NOT SAVE
Move the cursor to NOT SAVE and click Iris+ to exit the
menu without saving the settings
SAVE & END
Move the cursor to SAVE & END and click Iris+ to save
the setting and exit the menu.