Better Solutions Are Within Reach
Internal Speaker Enabled
The speakers inside the TV's cabinet normally are enabled. Sound is also routed externally to an attached pillow
speaker.
1.
Enter the Sound menu
Press CH▲ or CH▼ to highlight the component you want to change
2.
Press VOL◄ or VOL► to select Enabled or Disabled.
3.
4.
Press SETUP to return to the previous menu.
Minimum Volume
This sets the minimum volume level the TV can reach. For pillow speakers with an adjustment thumbwheel volume
control, ALWAYS set a minimum volume level for the TV. A minimum volume setting is usually not required for
pillow speakers with dedicated Volume Up and Down buttons.
NOTE: Setting this level to any value other than 0 guarantees that some level of sound will always
be heard when the TV is operating.
In the Sound menu, press CH▲ or CH▼ to highlight Minimum Volume.
1.
Press VOL◄ or VOL► to select the preferred minimum volume.
2.
Press the SETUP button to return to the preceding menu.
3.
Power on Volume
This sets the initial volume the TV starts at upon powering on. Once the TV is on, the volume can be set to any
allowable level.
In Sound menu, press CH▲ or CH▼ to highlight Power on Volume.
Press VOL◄ or VOL► to select the preferred volume when the TV turns on.
NOTE: Setting the level to LAST causes the TV to remember the last volume level used by the TV prior to
turning off.
Press the SETUP button to return to the preceding menu.
Cloning
Cloning allows quick programming of a TV using a USB Flash Drive. First a specimen TV is hand-programmed
using a programming remote control (PD108-420) with channels, sound, and other settings. While the TV is On a
USB Flash Disk is inserted into that TV's Clone port, the specimen TV's setup written to the Flash Disk, and then
the Flash Disk is removed to program other televisions. One Flash Disk can be used to program an entire hospital
of televisions.
Save Setting to USB Disk
1.
Turn the TV On.
2.
Insert a blank USB thumb Drive (user provided) into the USB Clone Port located adjacent the Cable TV Jack.
When the Cloning Main Menu appears, Press CH▲ or CH▼ to highlight Save Setting to USB Disk.
3.
Press VOL►to enter the save settings to USB menu.
4.
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 800-628-9870 FX 937-743-5664
MODEL NUMBER:
CV2600, CV3200
Healthcare LCD TV
TM
Document Number:
PD196-241R2
Page 8 of 9
Need help?
Do you have a question about the CV2600 and is the answer not in the manual?